|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
very good manual, with detail and clarity in esquematic diagrams and waveforms .
;
Very quality copy of original service manual, which contains the circuit diagrams, PCB and lists of components, well as recommendation for calibration procedures of device, also everything else, that need for repair, tuning and use this oscilloscope.
All presented copies have high-resolution, so you can view all in detail.
This manual will very useful for simple owners and for repairers.
I recommend these manual, because myself is owner of Philips PM3216 and I need sometimes servicing these oscilloscope (principally calibrating).
Also, these document is an example of excellent design of technical documentation.
;
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
A+++++++++++++++++++++++++
;
manual excelente completo , diagramas y esquemas bien presentados y buena calidad de imagen.
;
muy buen manual completo de buena calidad de impresion preciso y detallado , muy útil para la reparación.
(8)
For the FAX-270MC/290MC/520DT/520MC/MFC370MC/390MC: Take out the microphone* and its harness* from the control panel.
Bosses
Main-mike harness*
Latches
Control panel
* Provided on the FAX-270MC/290MC/520DT/520MC/ MFC370MC/390MC.
(9)
To take out the LCD, remove the control panel PCB and the FPC key in step (6). As shown below, insert the tip of a flat screwdriver under clamp �D� in the direction of arrow F and push up clamp �D� slightly to release the LCD from clamp �C.� In the same way, insert the screwdriver under clamp �A� to release the LCD from clamp �B.� Then push out the LCD with your fingers in the direction of arrow R.
F
"A" Flat screwdriver
R
"B"
LCD F (Rear) "C" R "D"
s Reassembling Notes � To put the LCD back into place, insert the tip of a flat screwdriver under clamp �D� (see the above illustration) in the direction of arrow R, push up clamp �D� slightly, and then put the right edge of the LCD under clamp �D.� In the same way, insert the screwdriver under clamp �A� to put the left edge of the LCD under clamp �A.� Then push the LCD into place with your fingers in the direction of arrow F. � � When installing the LCD, take care not to scratch or damage the cover sheet. Replace it if scratched or damaged. A new LCD is covered with a protection sheet. Before installing it, remove the protection sheet.
IV � 12
|
|
|
> |
|