|
Who's Online
There currently are 5911 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
got exactly what i ordered in a very timely manner. will use again for other manuals
;
I'm happy. Good quality. Very helped me with my work..............................
;
This is the second Manual I have ordered from owner-manuals, I give it five stars because it is exactly what I expected given the age of the equipment. So the contents look a bit aged and the pictures a bit grainy, it fulfills my needs and I am glad I can still get hold of them.
;
thank u so much for this manual that was so cheap that i thought it was a scam but i gambled anyway because it was too good of a deal to pass up and behold,the manual has everything and details of everything even the screws and im still amazed and very happy with my manual .so take my word and jump on it before they realize how cheap they selling thier manuals..thank you so much for taking time to read my thoughts
;
I do not have very much to say.
The price is quite covenient, delivery was better as promised (about 12 ours, against the specified 24 hours if I remember well), and the quality of the PDF is more than acceptable.
The Service Manual of Sansui R30 itself is also satisfactory: good graphic for schematics and layouts, simple and well structured.
Giovanni Bianchi
I-5
Dirt on the back of paper
<Printing> Possible cause Fixing unit Step 1 Check Is the pressure roller dirty? Is any other area in the printer dirty? Dirt in the drum unit 2 Is the transfer roller dirty? Is the problem solved after the drum unit is replaced? No Replace the high-voltage power supply PCB. Yes Result Yes Remedy Clean the pressure roller. (See the following note.) Replace the drum unit
Note: Clean the pressure roller as follows; (1) Set three or more sheets of paper in the MP sheet feeder. (2) Open the top cover. (3) Turn on the power switch while holding down the switch on the printer control panel. (4) Release the panel switch when the Drum lamp is on. (5) Close the top cover. (6) Hold down the panel switch until the Ready lamp is on, then release the switch. (7) Print three patterns; grid, zip and solid black. (8) Turn off the power switch with the top cover closed. (9) Set paper in the manual slot with the solid black side up. (10) Turn on the power switch while holding down the switch on the control panel. (11) Release the panel switch when the Drum lamp is on. (12) Press the panel switch again and release it immediately. (13) Print a page of test pattern while cleaning the pressure roller.
IV-10
|
|
|
> |
|